Easy DIY Draft Catcher
Is it still cold where you live? It’s still stinkin’ cold here and will probably be cold for another 3 months or so. Also, where I live the wind blows so bad, so many days, and it comes right in my doors. You see, I live in an older house and while this house is a work in progress, the doors are kind of drafty. Not so awesome when it’s 10 degrees outside. I put a towel at the front door and a blanket at the back door to help, but it was kind of tacky, so I made an Easy DIY Draft Catcher for each door. These babies are easy to make and really do help.
This is Louie. I’m pretty sure he liked the blanket at the back door more than he likes the draft catcher. He seems to lay a little bit away from the door now instead of right next to it. He just stares at the draft catcher. Kind of funny really. Poor mistreated cat.
This is what was at my front door before I decided to make it a little less tacky.
As I said, these are super easy to make. First, measure the doorway of where you want it to go and add 4 inches. Cut the fabric to that length and 10 inches wide. I used a metal tape measurer because I didn’t have a fabric one long enough for the back door fabric.
Fold the fabric in half, lengthwise, and sew along two sides. Trim the edges.
Cut the corner to take the point off of the fabric, as shown in the picture below. The turn the fabric right side out.
To stuff the draft catcher, you will need some fiberfill and bigger dried beans, like pinto beans.
To fill, first put about 2 cups of beans in the draft catcher. Then put some fiberfill in, to measure about a foot of fiberfill. Repeat until it is filled.
A couple of tips. First, when you’re adding your fiberfill, use a yard stick to push it down and pack it is well, a little at a time. Second, use a canning funnel to add the beans. I have beans all over the place now because I dropped some and Louie ran off with them.
You want to finish with beans and a small amount of fiberfill, as shown below. The beans on the ends help hold it in place.
Turn the edges under and sew the end closed. This will be a little tricky. Squish the filling down so you have room to sew the end closed. When you’ve got it closed, move it around a little to fill in where you squished it down.
Finally, you have a lovely draft catcher to keep the draft out of your house. This will help keep you warmer and help with your heating costs. The perfect win-win in my book. Do you have drafty doors or windows? You could use these at window openings too. Stay warm out there!
Other DIY Home Projects you may like…
This content may contain affiliate links. We earn a commission at no extra cost to you if you make a purchase. We may earn money, free services or complementary products from the companies mentioned in this post. All opinions are ours alone…